inlet side

英 [ˈɪnlet saɪd] 美 [ˈɪnlet saɪd]

入口端,进口侧

化学



双语例句

  1. The lower end of the housing is sealed, and the gas inlet ( 1) and the lower sampling valve ( 3) are respectively arranged on the side wall at the lower end.
    所述壳体下端封闭,其下端侧壁上分别设置有所述气体入口(1)和下采样阀(3)。
  2. The recommended concentration should be dissolved in a freshly prepared emulsion of the product in use and added slowly to the inlet side of the circulation pump to effect efficient dispersion.
    应将依建议调制的浓缩液溶解在新配制的乳化液中,然后缓慢加入循环泵的吸入口以便有效分散。
  3. The shutoff valve with the test cock is to be mounted on the inlet side of the backflow preventer.
    带测试旋塞的关闭阀安装在防回流阀的进口一侧。
  4. The test cock is on the inlet side of the shutoff valve.
    测试旋塞位于关闭阀的进口一侧上。
  5. The inlet of traffic hole at the left side Laxiwa hydropower station in Qinghai is introduced, and the excavating and supporting techniques in different soil conditions are proposed.
    介绍了青海拉西瓦水电站左岸低线交通洞进洞口,在不良地质条件下成洞的开挖和支护技术,可供同类工程参考。
  6. Pull off the vacuum line on the vacuum modulator on the inlet side.
    从进气侧的真空调节器上拔下真空管路。
  7. If a greenhouse is extra tight, the airflow from the inlet side of the house to the exhaust fan will be relatively well confined.
    如果温室很密闭,室内从进风面到排风扇的气流就比较好控制。
  8. The air inlet device comprises an air inlet pipe, a plurality of air inlets arranged on side face of the air inlet pipe, an air inlet pipe connection device.
    室体驱动装置由行驶装置及电机组成,进气装置包括进气管、设置在进气管侧面的若干进气口、及进风管连接装置;
  9. "D" type bearings with the lubrication mechanism of polymer, make the bearing surface, and return to the pump inlet side, in order to ensure the effective axis.
    “D”型轴承结合了强制润滑机理,使聚合物经轴承表面,并返回到泵的进口侧,以确保旋转轴的有效润滑。
  10. Poor sealing effects of temperature probe of scroll of bearing box at air inlet side of the air compressor results in oil contamination of following pipeline of air compressor.
    由于空压机进气侧轴承箱蜗壳温度探头密封效果不好,使空压机及其后续管道受到油污染。
  11. Open the inlet block valve on the hottest stream and establish circulation through this side of the exchanger.
    打开温度较高的产品流上的入口隔断阀,建立循环。
  12. The influence of the inlet temperature and mass flow of cooling water and the inlet temperature and mass flow of refrigerant water on refrigerant performance coefficient and optimal pressure at high pressure side of the transcritical CO2 heat pump system with expander is analyzed using the mathematical model.
    利用数学模型分析了冷却水进口温度和质量流量、冷冻水进口温度和质量流量对带膨胀机CO2跨临界热泵系统的制冷性能系数及最佳高压侧压力的影响。
  13. A optimized design code has been established for determining the heat transfer effectiveness of cross-flow heat exchanger with both fluids unmixed, accounting for the effect of the ununiformity of inlet fluid temperature of one fluid side.
    建立了在两侧流体均不混合的情况下,一侧流体进口温度不均匀对叉流换热器性能影响的最优设计模型,并在此基础上编制出空冷器最优设计程序。
  14. The numerical simulation of the axial vortex movement in the inlet side of the pump system with the method of discrete vortex provided a new way for hydromechanical characteristics of a pump system.
    用离散涡方法计算涡系位置的演化模拟泵入口侧涡量场的轴向涡流运动,为研究泵系统入流侧涡量场特性提供了一种定量研究方法。
  15. It is also found that there is a low density region behind the inlet and the jets branch off after impinging the boundary and the density near the side is higher than which in the middle of the channel.
    发现了大射流比下喷口附近存在一个相对的低密度区以及射流撞击底部后向侧壁分流、密度分布呈现中间低两侧高的现象。
  16. Studies on elbow inlet passage for side intake pumping stations
    有压侧向进水泵站肘形进水流道的试验研究
  17. Design of the Tray Under Large-Scale Atmospheric-Pressure Tower Tangent Inlet The new process gets the feed to low-pressure column from a side stream of high-pressure column, which balanced better the separation duties of the high-and low-pressure columns and implemented the integration of extracting soft-water.
    大型常压塔切向进料口下层塔盘结构设计该流程用加压塔侧线采出作为常压塔进料,更合理地分配了高、低压塔之间的分离负荷,并实现了萃取软水的集成利用。
  18. There is a difference between the numerical simulation results of two-dimensional and three-dimensional flow field in supersonic inlet, which shows the influence of boundary layer on the side wall.
    超声速进气道的三维流场数值模拟结果与二维数值模拟结果存在较明显的差别,说明进气道侧壁附面层的影响不容忽略;
  19. Experimental set-up is consists of a side inlet duct and a side circulating feed inlet, and venturi-pipe that was extensively used in industry as gas distributor.
    实验装置采用侧向进气结构和回料装置,气体分布器采用工业上推广使用的文丘里管。
  20. Flow resistance of inlet section of heat exchanger with longitudinal fluid flow in shell side
    轴流型换热器进口段流阻
  21. Increasing the inlet temperature and mass flow of refrigerant water is also favorable to increase refrigerant performance coefficient, but has no great influence on optimal pressure at high pressure side.
    提高冷冻水进口温度及质量流量有利于提高制冷性能系数,对最佳高压侧压力影响不大。
  22. Analysis to the Separation of Dust-air in the Double Turing Spin inlet passage of Cyclone at the Same side
    旋风器同侧双进口蜗向回转通道内气尘分离状况分析
  23. The obliquely inflowing current forms an asymmetric geomorphologic system in the tidal inlet, the tidal deltas are more developed on the east side of inner bay and on the northeast side of outer bay.
    由于水流的非正向入射,潮汐通道地貌体系不对称,潮流三角洲在湾内东侧发育、在湾外东北侧发育。
  24. The transient continuously distributive vortex can be replaced by a number of discrete point vortexes. The trajectory of vortex movement was computed with the method of discrete vortex and the axial vortex movement in the inlet side of the pump system was simulated.
    将泵入口侧连续分布的涡量场离散成有限数目的离散涡,用离散涡方法计算涡系位置的演化,模拟泵入口涡量场的轴向涡流运动。
  25. Reducing the inlet temperature of cooling water and increasing its mass flow are favorable to increase refrigerant performance coefficient, and can decrease optimal pressure at high pressure side.
    降低冷却水进口温度和提高其质量流量不仅有利于提高制冷性能系数,而且能降低最佳高压侧压力。
  26. The experimental results show that placement of suitable inlet weirs of unequal height can effectively restrain retrograde flow on each side of the tray to achieve uniform liquid flow on the whole tray.
    结果表明:设置不等高入口堰,可有效抑制板面两侧弧形区域的液体返混,达到整个板面液体均匀流动的效果。
  27. According to the research, the article pointed out that the return air inlet should be in the ceiling, we should set desk side boards.
    通过研究指出回风口宜设置在顶棚上,办公桌宜设置侧面隔板。